Commands Listed in Alphabetical Order
Syntax
CURSor:SCREEN
:XPOSITION<x>
CURSor:SCREEN:XPOSITION<x >?
CURSor:SCREE
N:YPOSITION<x>
This command sets or queries the y position of the specified screen cursor. The
cursor is specified by x, which can be 1 or 2. If the cursor is not specified, it
defaults to
cursor 1.
Group
Cursor
Syntax
CURSor:SCREEN:YPOSITION<x >
CURSor:SCREEN:YPOSITION<x >?
CURSor:SOUrce<x>
This command sets o r queries the source(s) for the currently selected cursor type.
The cursor is specified by x, which can be 1 or 2. If the cursor is not specified,
it defaults to cursor 1.
This command is equivalent to selecting Cursor Setup from the Cursors menu,
andthenchoosingthedesiredcursorsource.
Group
Cursor
Syntax
CURSor:SOUrce<x> {CH<x>|MATH<x>|REF <x>}
CURSor:SOUrce<x>?
Arguments
CH<x> sets an input channel waveform as the cursor source. The valid channel
waveform range is from 1 through 4.
MATH<x> sets a math waveform as the cursor source. The valid math waveform
range is from 1 through 4.
REF<x> sets a reference waveform as the cursor source. The valid reference
waveform range is from 1 through 4.
Returns
Any valid waveform.
2-136 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
