Tektronix DSA70000/B Series

Commands Listed in Alphabetical Order
Arguments
<NR1> any numer
ical nonzero, stops the acquisition.
OFF continues the acquisition.
ON stops the acquisition.
1 stops the acquisition.
0 continues the acquisition.
Examples
SEARCH:STOP 1 stops the acqui
sition.
SEARCH:STOP? might return :SEARCH:STOP 1, indicating that a search found
an event and stops acquisition.
SELect? (Query Only)
This query-only command returns the selected waveform that is affected by the
front panel controls and the display status (on or off) of all waveforms. This query
command is equivalent to selecting Measurement Setup from the Measure menu
and viewing the Source waveform setting.
Group
Vertical
Syntax
SELect?
Examples
SELECT? might return the waveform and status information as :SELECT:CH 1
1;CH2 0 ;CH3 0;CH4 0;MATH1 0; MATH2 0;MAT H3 0;MATH4 0;REF1
0;REF2 0; REF3 0;REF4 0;CONT ROL CH1
.
SELect:CH<x>
This command sets or queries the displayed s tate of the specified channel
waveform. The x can be channel 1 through 4.
Group
Vertical
Syntax
SELect:CH<x> {<NR1>|OFF|ON}
SELect:CH<x>?
Arguments
ON displays the indicate d channel waveform.
OFF turns off the display of the indicated channel waveform.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-487