Commands Listed in Alphabetical Order
Arguments
PASS opens a rel
ay passing your signal to the instrument.
BYPass closes a relay preventing your signal from reaching the instrument.
During probe d
egauss, the signal should be bypassed.
Examples
CH2:PROBE:SIGNAL PASS opens a relay passing your signal on Channel 2 to
the instrument.
CH1:PROBE:SIGNAL? might return :CH1:PROBE: SIGNAL BYPASS, indicating
that the relay is closed preventing your Channel 1 signal from reaching the
instrument.
CH<x>:PRObe:TIPtype
This command sets or queries the type of probe tip being used on the specified
channel.
Group
Vertical
Syntax
CH<x>:PRObe:TIPtype {HBWStraightfle x|OTHer}
CH<x>:PRObe:TIPtype?
Arguments
HBWStraightflex lets the instrument know you are using a high bandwidth
straight-flex probe tip.
OTHer lets the instrument know you are not using a high bandwidth straight-flex
probe tip.
Examples
CH1:PROBE:TIPTYPEHBWSTRAI GHTFLEX sets the c hannel 1 probe tip type to
HBWStraightflex.
CH1:PROBE:TIPTYPE? might return :CH1:PROBE:TIPTYPE OTHER, indicating
the probe tip is not an HBWStraightflex type.
CH<x>:PRObe:UNIts? (Query Only)
This query-only command returns a string describing the units of measure for
the probe attached to the specified channel. The channel is specified by x. The
value of x can range from 1 through 4.
Group
Vertical
2-124 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Need help?
General
