Commands Listed in Alphabetical Order
TRIGger:A:RS
232:PARity
DPO7000 Series only: This command sets or queries the state of the RS232
parity bit.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:RS232:PARity {NONe|EVEN|ODD}
TRIGger:A:RS232:PARity?
Arguments
NONe specifies no parity.
EVEN specifies even RS232 parity.
ODD specifies odd RS232 parity.
Exam
ples
TRIGGER:A:RS232:PARITY EVEN sets the RS232 parity to even.
TRIGGER:A:RS232:PARITY ? might return :TRIGGER:A:RS232:PARITY
ODD
, indicating that the RS232 parity is set to odd.
TRIGger:A:SERIAL:BITRate
This command sets or queries the clock/data bit rate. Changing the bit rate causes
t
he standard to become “custom”. It remains “custom” until another standard is
chosen.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:SERIAL:BITRate <NR3>
TRIGger:A:SERIAL:BITRate?
Arguments
<NR3> This is the series bit rate and is expressed in bits per second. The range is
1.5e6 to 1.25e9.
Examples
TRIGGER:A:SERIAL:BITRATE 51.8400E+6 sets the bit rate to 51.84
Mbits/second.
TRIGGER:A:SERIAL:BITRATE? might return:TRIGGER:A:SERIAL:BITRATE
51.8400E+6
, indicating that the bit rate is set to 51.84 Mbits/second.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-579
To Next Page
Loading...
Need help?
General
