Commands Listed in Alphabetical Order
Syntax
HORizontal[:M
AIn]:DELay:TIMe <NR3>
HORizontal[:MAIn]:DELay:T IMe?
Related Commands
HORizontal[:MAIn]:DELay:MODe, HORizontal[:MAIn]:DELay:POSition
Arguments
<NR3> specifies the time base trigger delay time setting, typically represented in
seconds.
Examples
HORIZONTAL:DELAY:TIME 5.0E-3 sets the time base trigger delay time to 5 ms.
HORIZONTAL:DELAY:TIME? might return :HORIZONTAL:MAI N:DELAY
5.0000E-05
, indicating that the time delay setting is 5 µs.
HORizontal:MAIn:INTERPRatio? (Query Only)
This query-only command returns the Horizontal Main time base interpolation
ratio. The ratio is useful for calculating the maximum sampling rate when users
request sampling rates that are faster than the maximum rate specified by the
acquisition hardware.
The default maximum sampling rate as specified by the acquisition hardware is 1.
An interpolation ratio other than 1 means that displayed and retrieved waveforms
contain a dditional points that are derived through interpolation. At such times,
the retrieved waveform data is actually 16-bit data. You should set the data width
accordingly.
Group
Horizontal
Syntax
HORizontal:MAIn:INTERPRat io?
Examples
HORIZONTAL:MAIN:INTERPRAT IO? might return
:HORIZONTAL:MAIN:INTERPRA TIO 10.0.
HORizontal[:MAIn]:POSition
Group
Horizontal
Syntax
HORizontal[:MAIn]:POSitio n <NR3>
HORizontal[:MAIn]:POSitio n?
2-258 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Need help?
General
