Commands Listed in Alphabetical Order
Group
Low Speed Seria
l Trigger
Syntax
TRIGger:A:CAN:SPEed <NR3>
TRIGger:A:CAN:SPEed?
Arguments
<NR3> specifies the bit rate of the CAN system. Possible values are 1M, 800K,
500K, 250K, 125K, 100K, 83.3K, 62,5K, 50K, 33K, 20K, and 10K.
Examples
TRIGGER:A:CAN:SPEED 33K sets the CAN systems with a bit rate of 33K.
TRIGGER:A:CAN:SPEED? might return TRIGGER:A:CAN:SPEED 50K,
indicating that the bit rate of the CAN system is set to 50K.
TRIGger:A:COMMunication:{AMI|HDB3|B3ZS|B6ZS|B8ZS}:PULSEForm
This entry covers five separate commands, one each for AMI and AMI subtypes.
The commands set or query the AMI pulse form to one of three possibilities.
Conditions
This command is only valid if the instrument has Option MTM is installed
Group
Trigger
Syntax
TRIGger:A:COMMunication:{A MI|HDB3|B3ZS|B6ZS|B8ZS}:PULSEForm
{PLUSOne|MINUSOne| EYEdiagram}
TRIGger:A:COMMunication:{A MI|HDB3|B3ZS|B6ZS|B8ZS}:PULSEForm?
Arguments
PLUSOne corresponds to the Isolated +1 on the front panel m enu.
MINUSOne corresponds to the Isolated -1 on the front panel menu.
EYEDiagram positions the trigger point off screen in order to display the eye.
Examples
TRIGGER:A:COMMUNICATION:AM I:PULSEFORM PLUSONE sets the pulse form
to PLUSONE.
TRIGGER:A:COMMUNICATION:AM I:PULSEFORM? might return
:TRIGGER:A:COMMUNICATION:A MI:PULSEFORM PLUSONE, indicating that the
AMI PULSFORM is set to PLUSONE.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-557
To Next Page
Loading...
Need help?
General
