Tektronix DSA70000/B Series

Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIGger:A:EDGE:SLOpe:MATH<x>
This command sets or queries the slope for an edge trigger search to determine
where to place a m ark. <x> is the s ea rch number or the math waveform number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :EDGE:SLOpe:MATH<x>
{RISe|FALL|EITher}
SEARCH:SEARCH<x>:TRIGger:A :EDGE:SLOpe:MATH<x>?
Arguments
RISe specifies a rising edge.
FALL specifies a falling edge.
EITHER specifi es either rising or falling edge.
Examples
SEARCH:SEARCH1:TRIGGER:A:E DGE:SLOPE:MATH2 RISE sets the Math 2
waveform slope for search 1 to rise.
SEARCH:SEARCH1:TRIGGER:A:E DGE:SLOPE:MATH1? might return
:SEARCH:SEARCH1:TRIGGER:A: EDGE:SLOPE:MATH1 RISE, indicating that
the slope for the Math 1 waveform trigger f or search 1 is rise.
SEARCH:SEARCH<x>:TRIGger:A:EDGE:SLOpe:REF<x>
This command sets or queries the slope for an edge trigger search to determine
where to place a mark. <x> is the search number or the reference waveform
number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :EDGE:SLOpe:REF<x>
{RISe|FALL|EITher}
SEARCH:SEARCH<x>:TRIGger:A :EDGE:SLOpe:REF<x>?
Arguments
RISe specifies a rising edge.
FALL specifies a falling edge.
EITHER specifi es either rising or falling edge.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-443