Commands Listed in Alphabetical Order
HORizontal:F
ASTframe:SEQuence
This command sets or queries the FastFrame single-sequence mode stop condition.
Group
Horizontal
Syntax
HORizontal:FASTframe:SEQue nce {FIRst|LAST}
HORizontal:FASTframe:SEQue nce?
Arguments
FIRst sets single sequence to stop after n frames.
LAST sets single sequence to stop manually.
Examples
HORIZONTAL:FASTFRAME:SEQUE NCEFirst sets single-sequence mode to s t op
after n frames.
HORIZONTAL:FASTFRAME:SEQUE NCE? might return
:HORIZONTAL:FASTFRAME:SEQU ENCE LAST, indicating the FastFrame
single-sequence mode is stop manually.
HORizontal:FASTframe:STATE
This command sets or returns the state of FastFrame acquisition. This is equivalent
to setting FastFrame to On in the FastFrame Setup menu. FastFrame lets users
capture a series of triggered acquisitions with minimal time between them.
The digitizing instrument in FastFrame mode is ready to accept a continuous burst
of triggers 400 ms after the controller sends the ACQuire:STATE RUN command.
Group
Horizontal
Syntax
HORizontal:FASTframe:STATE {ON|OFF|<NR1>}
HORizontal:FASTframe:STATE ?
Related Commands
ACQuire:STATE
Arguments
<ON> turns on horizontal FastFrame.
<OFF> turns off horizontal FastFrame.
<NR1> = 0 turns o ff horizontal FastFrame; any other value turns on horizontal
FastFrame.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-247
To Next Page
Loading...
Need help?
General
