Commands Listed in Alphabetical Order
Syntax
TRIGger:A:I2C
:ADDRess:TYPe
{GENeralcall|STARtbyte|TEN bit|NONe}
TRIGger:A:I2C:ADDRess:TYPe ?
Arguments
GENERALCALL specifies a generalcall address type.
STARTBYTE specifies a startbyte address type.
TENBIT specifies a tenbit address type.
NONE specifies I2C address type of none.
Examples
TRIGGER:A:I2C:ADDRESS:TYPE NONE setstheI2Caddresstypetonone.
TRIGGER:A:I2C:ADDRESS:TYPE ? might return
:TRIGGER:A:I2C:ADDRESS:TYP E TENBIT, indicating that the I2C address
type is set to tenbit.
TRIGger:A:I2C:ADDRess:VALue
DPO7000 Series only: This command sets or queries the binary address string
used for the I2C trigger if the trigger condition is ADDR or ADDRANDDATA.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:I2C:ADDRess:VALu e <String>
TRIGger:A:I2C:ADDRess:VALu e?
Arguments
String is up to 7 or 10 bits depending on the address mode that specifies the
address.
Examples
TRIGGER:A:I2C:ADDRESS:VALU E 1011 sets the I2C address value to 1011.
TRIGGER:A:I2C:ADDRESS:VALU E? might return
:TRIGGER:A:I2C:ADDRESS:VAL UE 10111, indicating that the I2C address
value is set to 10111.
TRIGger:A:I2C:CLOCk:LEVel
DPO7000 Series only: This command sets or queries the clock source for the
I2C Serial Trigger.
Group
Low Speed Serial Trigger
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-569
To Next Page
Need help?
General
