Tektronix DSA70000/B Series

Commands Listed in Alphabetical Order
Examples
TRIGGER:MULTI
SCOPE:ALIGN
starts the TekLink trigger a lignment procedure
on all the oscilloscopes that are participating in MultiScope triggering.
TRIGger:MULTiscope:ALIGN:COMPleted? (Query Only)
This command returns whether the oscilloscope has successfully completed the
MultiScope trigger align procedure.
Group
TekLink
Syntax
TRIGger:MULTiscope:ALIGN:C OMPleted?
Returns
TRUe when the MultiScope trigger align procedure has successfully completed.
FALSe when the MultiScope trigger align procedure fails.
Examples
TRIGGER:MULTISCOPE:ALIGN:C OMPLETED? might return
:TRIGGER:MULTISCOPE:ALIGN: COMPLETED TRUE, indicating that
the MultiScope trigger align procedure has successfully completed.
TRIGger:MULTiscope:ALIGN:SETSTATE
This command causes the instrument to measure the round trip time between
sending a trigger out the TekLink port and receiving the trigger pulse back from
the port.
Group
TekLink
Syntax
TRIGger:MULTiscope:ALIGN:S ETSTATE {START|STOP|WAIT| DONE}
TRIGger:MULTiscope:ALIGN:S ETSTATE?
Related Commands
TRIGger:MULTiscope:ALIGN:VALue?
Arguments
START begins calibration.
STOP ends calibration.
WAIT postpones calibration.
DONE indicates that the calibration
is complete.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-619