Tektronix DSA70000/B Series

Commands Listed in Alphabetical Order
Examples
SEARCH:SEARCH
1:TRIGGER:A:DDRMEMORY:REFLEV EL:STROBE:MID 3
sets
the strobe MID reference level to 3.0 volts.
SEARCH:SEARCH1:TRIGGER:A:D DRMEMORY:REFLEVEL:STROBE:MID? might
return
:SEARCH:SEARCH1:TRIGGER:A:D DR
MEMORY:REFLEVEL:STROBE:MID
0.0000
, indicating that the strobe MID reference level is set to 0 volt.
SEARCH:SEARCH<x>:TRIGger:A:DDRMemory:STANdard
This command sets or queries the DDR standard for a DDR Memory analysis
search to determine w here to place a mark. <x> is the search number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x
>:TRIGger:A:DDRMemory:STAN dard
{DDR|DDR2|DDR3|GDDR3|LPDDR }
SEARCH:SEARCH<x>:TRIGger:A :DDRMemory:STANdard?
Arguments
<DDR> sets the DDR standard type to DDR.
<DDR2> sets the DDR standard type to DDR2.
<DDR3> sets the DDR standard type to DDR3.
<GDDR3> sets the DDR standard type to GDDR3.
<LPDDR> sets the DDR standard type to LPDDR.
Examples
SEARCH:SEARCH1:TRIGGER:A:D DRMEMORY:STANDARD DDR2 sets the DDR
standard to DDR2.
SEARCH:SEARCH1:TRIGGER:A:D DRMEMORY:STANDARD? might return
:SEARCH:SEARCH1:TRIGGER:A: DDRMEMORY:STANDARD DDR3, indicating
that the DDR standard is set to DDR3.
SEARCH:SEARCH<x>:TRIGger:A:DDRMemory:STROBEsource
This command sets or queries the strobe source for a DDR Memory analysis
search to determine w here to place a mark. <x> is the search number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :DDRMemory:STROBEsource
{CH1|CH2|CH3|CH4|MATH1|MAT H2|MATH3|MATH4|REF1|REF2|REF3|REF4}
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-441