Commands Listed in Alphabetical Order
MATH<x>:SPEC
Tral:SUPPress
This command sets or returns the phase suppression thre shold for the specified
math waveform. The Math waveform is specified by x, which ranges from 1
through 4. Th
is command is equal to selecting Spectral Setup from the Math
menu, choosing the Phase tab and then entering a value in the Suppression
Threshold box. This command affects only Spectral Phase waveforms.
Group
Math
Syntax
MATH<x>:SPECTral:SUPPress <NR3>
MATH<x>:SPECTral:SUPPress ?
Related Commands
MATH<x>:SPECTral:UNWRap
Arguments
<NR3> is the magnitude level that data with magnitude values below this value
are displayed as zero phase.
Examples
MATH1:SPECTRAL:SUPPRESS -62 specifies that any d ata with magnitude values
less than -62 dB will have their phase output set to zero.
MATH1:SPECTRAL:SUPPRESS? might return : MATH1:SPECTRAL:SUPPRESS
-3.5000E+01
, indicating that the phase suppression threshold is currently set to
-35 dB.
MATH<x>:SPECTral:UNWRap
This command sets or returns whether phase unwrap of the spectral analyzer
output data is enabled for the specified math waveform. The Math waveform is
specified by x, which ranges from 1 through 4. This command is equal to selecting
Spectral Setup from the Math menu, choosing the Phase tab and then clicking the
Unwrap button. This command affects only Spectral Phase waveforms.
Group
Math
Syntax
MATH<x>:SPECTral:UNWRap {ON|OFF}
MATH<x>:SPECTral:UNWRap?
Related Commands
MATH<x>:SPECTral:SUPPress
2-358 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
