Tektronix DSA70000/B Series Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
MASK:TESt:BEE
P:COMPLetion {OFF|ON|<NR1>}
MASK:TESt:BEEP:COMPLetion ?
Arguments
ON turns on the pass/fail beep on completion.
OFF turns off the pass/fail beep on completion.
<NR1> = 0 turns off the pass/fail beep on completion, any other integer turns
on the pass/fail beep on completion.
Examples
MASK:TEST:BEEP:COMPLETION ON turns on pas/fail beep on completion.
MASK:TEST:BEEP:COMPLETION ? might return
:MASK:TEST:BEEP:COMPLETIO N ON, indicating that the pass/fail beep on
completion is turned on.
MASK:TESt:BEEP:FAILure
This command sets or returns the beep status on pass/fail test failure mode. When
enabled, this command causes the instrument to e mit a tone when the pass/fail
status changes to ‘Failing’.
Group
Mask
Syntax
MASK:TESt:BEEP:FAILure {OFF|ON|<NR1>}
MASK:TESt:BEEP:FAILure?
Arguments
ON turns on the pass/fail beep on failure .
OFF turns off the pass/fail beep on failure. This is the default.
<NR1> = 0 turns off the pass/fail beep on failure, and any other integer turns on
the p ass/fail beep on failure.
Examples
MASK:TEST:BEEP:FAILURE OFF turns off the pass/fail beep on failure.
MASK:TEST:BEEP:FAILURE? might
return
:MASK:TEST:BEEP:FAILURE ON,
indicating that the p ass/fail beep on failure is turned on.
MASK:TESt:DELay
This command sets or returns the amount of time, in seconds, to wait after starting
pass/fail testing to evaluate waveforms. This is useful if the test system requires
‘settling’ time before evaluating waveforms.
2-326 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix DSA70000/B Series Specifications

General

Brand	Tektronix
Model	DSA70000/B Series
Category	Test Equipment
Language	English