Commands Listed in Alphabetical Order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:TRANsition:THR eshold:LOW:REF<x>
<NR3>
SEARCH:SEARCH<x>:TRIGger:A :TRANsition:THReshold:LOW:REF<x>?
Arguments
<NR3> specifies the LOW threshold in volts.
Examples
SEARCH:SEARCH1:TRIGGER:A:T RANSITION:THRESHOLD:LOW:REF2 0.5
sets the Reference 2 waveform transition trigger LOW threshold setting for search
1to0.5volts.
SEARCH:SEARCH1:TRIGGER:A:T RANSITION:THRESHOLD:LOW:REF1? might
return
:SEARCH:SEARCH1:TRIGGER:A:T RANSITION:THRESHOLD:LOW:REF1
800.0000E–3
, indicating that the Reference 1 waveform transition trigger LOW
threshold setting for search 1 is set to 0.8 volts.
SEARCH:SEARCH<x>:TRIGger:A:TRANsition:WHEn
This command sets or queries the condition setting for a transition trigger search
to determine where to place a mark. <x> is the search number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :TRANsition:WHEn
{FASTERthan|SLOWERthan}
SEARCH:SEARCH<x>:TRIGger:A :TRANsition:WHEn?
Arguments
FASTERthan sets the trigger to occur when the transitioning signal is faster than
the set volts/second rate.
SLOWERthan sets the trigger to occur when the transitioning signal is slower
than the set volts/second rate.
Examples
SEARCH:SEARCH1:TRIGGER:A:T RANSITION:WHEN SLOWERTHAN sets the
transition trigger condition setting for search 1 to SLOWERTHAN.
SEARCH:SEARCH1:TRIGGER:A:T RANSITION:WHEN? might return
:SEARCH:SEARCH1:TRIGGER:A: TRANSITION:WHEN FASTERTHAN, indicating
that the transition trigger condition setting for search 1 is set to FASTERTHAN.
SEARCH:SEARCH<x>:TRIGger:A:TYPe
This command sets or queries the trigger type setting for a search to determine
where to place a mark. <x> is the search number.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-477
To Next Page
Loading...
