Tektronix DSA70000/B Series Programmer's Manual

Commands Listed in Alphabetical Order
WFMInpre:PT_
Off
This command specifies or returns the trigger point within the waveform record
for the reference waveform specified by the DATa:DESTination command.
Group
Waveform Transfer
Syntax
WFMInpre:PT_Off <NR1>
WFMInpre:PT_Off?
Related Commands
DATa:DESTination, DATa:STARt, WFMOutpre:PT_Off?
Arguments
<NR1> is -(record length -1) to record length and is the position of the data
point immediately following the actual trigger.
<NR1> is expressed relative
to DATa:STARt.
Examples
WFMINPRE:PT_OFF 1 specifies that the trigger point is the same as the Data:Sta rt
point.
WFMINPRE:PT_OFF? might return : WFMINPRE:PT_OFF 0, i ndicating that the
incoming waveform trigger point is the first point in the waveform record.
WFMInpre:WFId (No Query Form)
This command (no query form) accepts but ignores the argument. This command
is provided only to allow a waveform extracted from the instrument to be easily
imported.
Group
Waveform Transfer
Syntax
WFMInpre:WFId <QString>
Related Commands
DATa:DESTination, WFMInpre:BN_Fmt, WFMInpre:ENCdg,
WFMOutpre:WFId?
Arguments
<QString> must be a valid IEEE-488.2 string (but the contents are ignored).
Examples
WFMINPRE:WFID "CH1, DC
COUPLING, 2.000V/DIV, 4 00.0NS/DIV,
500 POI NTS, SAMPLE MODE"
is a syntactically correct command.
2-634 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix DSA70000/B Series Specifications

General

Brand	Tektronix
Model	DSA70000/B Series
Category	Test Equipment
Language	English