Commands Listed in Alphabetical Order
ZOOm:VERTica
l:SCAle
This command sets or queries the zoom vertical scale factor around which the
zoom waveform is displayed.
Group
Zoom
Syntax
ZOOm:VERTical:SCAle <NR3>
ZOOm:VERTical:SCAle?
Arguments
<NR3> is the amount of expansion in the vertical direction in 1-2-5 increments.
Examples
ZOOM:VERTICAL:SCALE 5 sets the vertical scale to 5.
ZOOM:VERTICAL:SCALE? might return :ZOOM:VERTICAL:SCALE 10,
indicating that the vertical scale is set to 10.
ZOOm:ZOOM<x>
This command res ets the zoom transforms to default values for all traces of
the specified zoom, where x is an integer from 1 to 4 repres enting the desired
zoom window. The ZOOm:REF<x>:VERTical:SCAle? query returns the current
vertical and horizontal positioning and scaling of the display.
Group
Zoom
Syntax
ZOOm:ZOOM<x> {RESET|RESETLive}
ZOOm:ZOOM<x>?
Arguments
RESET resets the zoom transforms to default value s for all traces of the specified
zoom.
RESETLive r esets the zoom transforms to default values for live traces of the
specified zoom.
Examples
ZOOM:ZOOM1 RESET resets the zoom transforms for all traces of Zoom1 to their
default values
ZOOM:ZOOM1? might return :ZOOM:ZO OM1:STATE 1;SCROLLLOCK
1; CH1: HORIZONTAL POSITION 50.0000;SCALE 5;
:ZOOM:ZOOM1:CH1:VERTICAL: POSITION 0.0000; SCALE
1.0000; :ZOOM:ZOOM1:CH2:HORIZONTAL:POSTIO N 50.0000;
2-658 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
