Commands Listed in Alphabetical Order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:STATE:WHEn {TRUe|FALSe}
SEARCH:SEARCH<x>:TRIGger:A :STATE:WHEn?
Arguments
TRUe specifies a TRUE logic level.
FALSe specifies a FALSE logic level.
Examples
SEARCH:SEARCH1:TRIGGER:A:S TATE:WHEN FALSE sets the state trigger logic
level for search 1 to FALSE.
SEARCH:SEARCH1:TRIGGER:A:S TATE:WHEN? might return
:SEARCH:SEARCH1:TRIGGER:A: STATE:WHEN TRUE, indicating that the state
trigger logic level for search 1 is set to TRUE.
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:POLarity:CH<x>
This command sets or queries the polarity for a timeout trigger search to determine
where to place a mark. <x> is the search number or channel number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :TIMEOut:POLarity:CH<x>
{STAYSHigh|STAYSLow|EITher }
SEARCH:SEARCH<x>:TRIGger:A :TIMEOut:POLarity:CH<x>?
Arguments
STAYSHigh specifies the polarity stays HIGH.
STAYSLow specifies the polarity stays LOW.
EITher specifies the polarity either stays HIGH or stays LOW.
Examples
SEARCH:SEARCH1:TRIGGER:A:T IMEOUT:POLARITY:CH2 STAYS LOW sets the
Channel 2 timeout trigger polarityforsearch1toSTAYSLOW.
SEARCH:SEARCH1:TRIGGER:A:T IMEOUT:POLARITY:CH1? might return
:SEARCH:SEARCH1:TRIGGER:A: TIMEOUT:POLARITY:CH1 STAY SHIGH,
indicating that the Channel 2 timeout trigger polarity for search 1 is set to
STAYSHIGH.
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:POLarity:MATH<x>
This command sets or queries the polarity for a timeout trigger search to determine
where to place a mark. <x> is the search number or math waveform number.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-469
To Next Page
Loading...
