Tektronix DSA70000/B Series Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
NEWpass <QStri
ng>
Related Commands
PASSWord, *PUD
Arguments
<QString> is the new password, which can contain up to 10 characters.
Examples
NEWPASS "mypassword" creates a new password (mypassword) for accessing
your protected data.
*OPC
This command generates the operation complete mes sage in the Standard Event
Status Register (SESR) when all pending commands that generate an OPC
message are complete. The *OPC? query places the ASCII character “1” into the
output queue when all such OPC commands are complete. The *OPC? response is
not available to read until all pending operations finish. For a complete discussion
of the use of these registers and the output queue, see Registers a nd Queues.
The * OPC command allows you to synchronize the operation of the instrument
with your application program. For more information, see Synchronization
Methods.
Table 2-18: Commands that Generate an OPC M essage
Operation Command
Single sequence acquisition ACQuire:STATE ON or
ACQuire:STATE RUN or
ACQuire:STATE 1 (when ACQuire:STOPAfter is set to
SEQuence)
Starts diagnostics DIAg:EXECUTE
Calibration step Refer to the Service Manual.
Test execution
TEST
*RST, FACtory, TEKSecure
Recall setup
*RCL, RECAll:SETUp
Group
Status and Error
Syntax
*OPC
*OPC?
Related Commands
BUSY?, *WAI
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-411

Tektronix DSA70000/B Series Specifications

General

Brand	Tektronix
Model	DSA70000/B Series
Category	Test Equipment
Language	English