Tektronix DSA70000/B Series

Commands Listed in Alphabetical Order
CH<x>:PRObe:
AUTOZero (No Query Form)
This command sets the probe attached to the input to autozero. The channel is
specified by x. The value of x can range from 1 through 4.
Group
Vertical
Syntax
CH<x>:PRObe:AUTOZero EXECute
Arguments
EXECUTE sets the probe attached to the specified channel to autozero.
Examples
CH1:PROBE:AUTOZERO EXECUTE sets the probe attached to the Channel 1 to
autozero.
CH<x>:PRObe:DEGAUSS (No Query Form)
This command starts a degauss cycle of the probe attached to the specified
channel. The channel is specified by x. The value of x can range from 1 through 4.
Group
Vertical
Syntax
CH<x>:PRObe:DEGAUSS EXECute
Arguments
EXECUTE starts the degauss cycle.
Examples
CH1:PROBE:DEGAUSS EXECUTE causes the probe attached to Channel 1 to
degauss.
CH<x>:PRObe:DEGAUSS:STATE? (Query Only)
This command queries whether the probe attached to the specified channel ha s
been degaussed.
Group
Vertical
Syntax
CH<x>:PRObe:DEGAUSS:STATE ?
2-116 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual