Commands Listed in Alphabetical Order
MASK:COUNt:F
AILURES? (Query Only)
This query-only command returns the number of pass/fail tests that have failed.
The default is 0. Pass/fail testing must be enabled.
Group
Mask
Syntax
MASK:COUNt:FAILURES?
Returns
<NR1>
Examples
MASK:COUNT:FAILURES? might return: MASK:COUNT:FAILU RES 0,showing
that no tests have failed.
MASK:COUNt:HITS? (Query Only)
This query-only command returns the number of h its on all mask segments. Hit
counting must be turned on.
Group
Mask
Syntax
MASK:COUNt:HITS?
Returns
<NR1>
Examples
MASK:COUNT:HITS? might return :MASK:COUNT:H ITS 0,showingtherewere
no hits from any source on any mask segments.
MASK:COUNt:SEG<m>:HITS? (Query Only)
This query-only command returns the number of hits in mask segment <m>. Hit
counting must be turned on.
Group
Mask
Syntax
MASK:COUNt:SEG<m>:HITS?
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-301
To Next Page
Loading...
