Commands Listed in Alphabetical Order
Group
Low Speed Seria
l Trigger
Syntax
TRIGger:A:I2C:ADDRess:MOD e {ADDR7|ADDR10}
TRIGger:A:I2C:ADDRess:MOD e?
Arguments
ADDR7 specifies the 7-bit I2C address mode.
ADDR10 specifi es the 10-bit I2C address mode.
Examples
TRIGGER:A:I2C:ADDRESS:MOD E ADDR10 sets the I2C address mode to 10-bit.
TRIGGER:A:I2C:ADDRESS:MOD E? might return
:TRIGGER:A:I2C:ADDRESS:MO DE ADD7, indicating that the I2C address
mode is set to 7-bit.
TRIGger:A:I2C:ADDRess:RWINClude
Sets the I2C read/write bit to address type.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:I2C:ADDRess:RWI NClude {OFF|ON}
TRIGger:A:I2C:ADDRess:RWI NClude?
Arguments
ON specifies the I2C read/write bit to address type.
OFF specifies to stop the I2C read/write bit to address type.
Examples
TRIGGER:A:I2C:ADDRESS:RWI NCLUDE ON sets the read/write bit to address
type.
TRIGGER:A:I2C:ADDRESS:RWI NCLUDE? might return
:TRIGGER:A:I2C:ADDRESS:RW INCLUDE OFF, indicating that the
read/write bit stops specifying the address type.
TRIGger:A:I2C:ADDRess:TYPe
DPO7000 Series only: This command sets or queries the I2C address type.
Group
Low Speed Serial Trigger
2-568 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
