Commands Listed in Alphabetical Order
ZOOm:STATE
This command sets or queries the specifi ed zoom on or off.
Group
Zoom
Syntax
ZOOm:STATE {ON|OFF|<NR1>}
ZOOm:STATE?
Arguments
ON turns zoom on o r off.
OFF turns zoom on or off.
<NR1> = 0 disables the zoom; any other value enables the zoom.
Examples
ZOOM:STATE ON turns zoom on.
ZOOM:STATE? might return :ZOOM:STATE 1, indicating that z oom is on.
ZOOm:VERTical:POSition
This command sets or queries the v ertical position around which the zoom
waveform is displayed. It is freely movable within the confines of the acquired
waveform (0% to 100%) and measured from left to right of the acquired waveform.
Group
Zoom
Syntax
ZOOm:VERTical:POSition <NR3>
ZOOm:VERTical:POSition?
Arguments
NR3 is a value from 0 to 100.00 and is the percent of the waveform that is to the
left of screen center, when the zoom factor is 1× or greater.
Examples
ZOOM:VERTICAL:POSITION 50 sets the vertical position to 50.
ZOOM:VERTICAL:POSITION? might return :ZOOM:VERTICAL:POSITION
23.90000
, indicating that the vertical position is set to 23.9.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-657
To Next Page
Loading...
Need help?
General
