Commands Listed in Alphabetical Order
Syntax
MASK:AUTOAdju
st:VDELTA {<NR3>}
MASK:AUTOAdjust:VDELTA?
Arguments
<NR3> is a floating point number that represents a percent of a division.
Examples
MASK:AUTOADJUST:VDELTA 0.6 sets the vertical autofit search to 0.6 of a
division.
MASK:AUTOADJUST:VDELTA? might return :MASK:AU TOADJUST:VDELTA 2,
indicating that the vertical autofit search is set to 2 divisions.
MASK:AUTOSet:AUTOAdjust
This command sets or returns whether the instrument settings are automatically
matched to signal characteristics and specific mask requirements. It controls what
happens at the end of a mask autoset. If ON, the horz/vert auto adjustment is run
ONCE to potentially improve the result of mask autoset.
This command, like all the MASK:AUTOSET commands, affects only an autoset
on a standard mask, not the general instrument autoset function.
Group
Mask
Syntax
MASK:AUTOSet:AUTOAdjust {ON|OFF|<NR1>}
MASK:AUTOSet:AUTOAdjust?
Arguments
ON enables the autoset:autoadjust function.
OFF disables the autoset:autoadjust function.
<NR1> = 0 disables the autoset:autoadjust function; any other value enables it.
Examples
MASK:AUTOSET:AUTOADJUST ON enables the autoset autoadjust function.
MASK:AUTOSET:AUTOADJUST? might return :MASK:AUTOSET:AUTOADJUST 1,
indicating that the autoset:autoadjust function is enabled.
MASK:AUTOSet:HPOS
This command controls whether the autoset algorithm will attempt to change
the horizontal position o f the signal while attempting to do a mask autoset. The
default is ON.
2-288 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
