Tektronix DSA70000/B Series Programmer's Manual

Commands Listed in Alphabetical Order
Related Commands
DATa:SOUrce, W
FMOutpre:XUNit?
Examples
WFMOUTPRE:XZERO? might return :WFMOUTPRE:XZERO 5.6300E-9, indicating
that the trigger actually occurred 5.63 ns before the trigger sample.
WFMOutpre:YMUlt? (Query Only)
This query-only command returns the vertical scale factor per digitizing level
in units specified by WFMOutpre:YUNit for the waveform specified by the
DATa:SOUrce command. For those formats in which WFMOutpre:BYT_Nr is
important (all non-floating point formats), WFMOutpre:YMUlt? must take the
location of the binary point implied by BYT_NR into consideration.
An error is reported if the DATa:SOUrce waveform does not exist.
Group
Waveform Transfer
Syntax
WFMOutpre:YMUlt?
Related Commands
DATa:SOUrce
Examples
WFMOUTPRE:YMULT? might return :WFMOUTPRE:YMULT 4.0000E-3, indicating
that the vertical scale for the corresponding waveform is 100 mV/div.
WFMOutpre:YOFf? (Query Only)
This query-only command returns the vertical offset in digitized levels for the
waveform specified by the DATa:SOUrce command. For those formats in which
BYT_NR is important (all non-floating point formats), this command must take the
location of the binary point implied by WFMOutpre:BYT_Nr into consideration.
An error is reported if the DATa:SOUrce waveform does not exist.
Group
Waveform Transfer
Syntax
WFMOutpre:YOFf?
Related Commands
DATa:SOUrce, WFMOutpre:BYT_Nr
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-647

Tektronix DSA70000/B Series Specifications

General

Brand	Tektronix
Model	DSA70000/B Series
Category	Test Equipment
Language	English