Commands Listed in Alphabetical Order
NR1=0 stops acq
uisitions; any other value starts acquisitions.
Examples
ACQUIRE:STATE RUN starts the acquisition of waveform data and resets the count
of the number
of acquisitions.
ACQUIRE:S
TATE?
might return :ACQUIRE :STATE 0, indicating that the
acquisition is stopped.
ACQuire:STOPAfter
This command sets or queries whether the instrument continually acquires
acquisitions or acquires a single sequence. Pressing SINGLE on the front
panel b utton is equivalent to sending these commands:
ACQUIRE:STOPAFTER
SEQUENCE
and ACQUIRE:STATE 1.
Group
Acquisition
Syntax
ACQuire:STOPAfter {RUNSTop|SEQuence }
ACQuire:STOPAfter?
Related Commands
ACQuire:STATE
Arguments
RUNSTop specifies that the instrument will continually acquire data, if
ACQuire:STATE is turned on.
SEQuence specifies that the next acquisition w ill be a single-sequence acquisition.
Examples
ACQUIRE:STOPAFTER RUNSTOP sets the instrument to continually acquire data.
ACQUIRE:STOPAFTER? might return:ACQUIRE: STOPAFTER SEQUENCE,
indicating that the next acquisition the instrument makes will be of the
single-sequence type.
ALIas
This command sets or queries the state of alias functionality.
Group
Alias
Syntax
ALIas { OFF|ON|<NR1>}
ALIas?
2-82 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
