Commands Listed in Alphabetical Order
Arguments
FALL specifies t
he falling edge of the waveform.
RISE specifi es the rising edge of the waveform.
Examples
MEASUREMENT:MEAS3:DELAY:E DGE2 RISE specifies that the rising edge of the
waveform be used for measurement 3.
MEASUREMENT:MEAS1:DELAY:E DGE2? might return
:MEASUREMENT:MEAS1:DELAY: EDGE2 FALL, indicating that the falling edge
of the waveform is being us ed for measurement 1.
MEASUrement:MEAS<x>:MAXimum? (Query Only)
This query-only command returns the maximum value found for this measurement
since the last statistical reset. Measurements are specifi ed by x, which ranges
from 1 through 8.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:MAXim um?
Examples
MEASUREMENT:MEAS3:MAXIMUM ? might return
:MEASUREMENT:MEAS3:MAXIMU M 4.18E-9.
MEASUrement:MEAS<x>:MEAN? (Query Only)
This query-only command returns the mean value accumulated for this
measurement since the last statistical reset. Measurements are specified by x,
which ranges from 1 through 8.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:MEAN?
Examples
MEASUREMENT:MEAS1:MEAN? might r eturn :MEASUREMENT:MEAS1: MEAN
514.71E-09.
2-386 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
