Commands Listed in Alphabetical Order
Syntax
WFMInpre:BN_F
mt {RI|RP |FP}
WFMInpre:BN_Fmt?
Related Commands
WFMOutpre:BN_Fmt
Arguments
RI specifies signed integer data point representation.
RP specifies positive integer data point representation.
FP specifies single-pre cision binary floating point representation.
Examples
WFMINPRE:BN_FMT FP specifies that incoming data will be interpreted as
single-precision binary floating point numbers.
WFMINPRE:BN_FMT? might return :WFMINPRE:BN_FMT RI, indicating that the
incoming data is currently interpreted as signed integers.
WFMInpre:BYT_Nr
This command sets or returns the binar
y field data width for the first ordered
waveform, as specified by the DATa:DESTination command. This specification is
only meaningful when WFMInpre:ENCdg is set to BIN and WFMInpre:BN_Fmt
is set to either RI or RP.
Group
Waveform Transfer
Syntax
WFMInpre:BYT_Nr <NR1>
WFMInpre:BYT_Nr?
Related Commands
DATa:DESTination, WFMInpre:BN_Fmt, WFMInpre:ENCdg,
WFMInpre:BIT_Nr, WFMOutpre:BYT_Nr
Arguments
<NR1> is the number of bytes per data point and can be 1, 2 (RI, RP) or 4 (FP).
Examples
WFMINPRE:BYT_NR 1 sets the number of bytes per incoming waveform d ata
point to 1, which is the default setting.
WFMINPRE:BYT_NR? might return :WFMINPRE:BYT_NR 2 indicating that there
are 2 bytes per incoming waveform data point.
2-630 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
