Commands Listed in Alphabetical Order
TRIGger:{A|B
}:LOGIc:SETHold:HOLDTime
This command sets or queries the hold time for setup and hold violation triggering.
This command is equivalent to selecting Setup/Hold Setup from the Trig menu
andthensett
ing the desired Hold Time.
Group
Trigger
Syntax
TRIGger:{A|B}:LOGIc:SETHol d:HOLDTime <NR3>
TRIGger:{A|B}:LOGIc:SETHol d:HOLDTime?
Related Commands
TRIGger:{A|B}:LOGIc:SETHold:SETTime
Arguments
<NR3> specifies the hold time setting in seconds. Positive values for hold time
occur after the clock edge. Negative v alues occur before the clock edge.
Examples
TRIGGER:A:LOGIC:SETHOLD:HO LDTIME 3.0E-3 sets the hold time for the
setupandholdtriggerto3ms.
TRIGGER:A:LOGIC:SETHOLD:HO LDTIME? might return
:TRIGGER:A:LOGIC:SETHOLD:H OLDTIME 2.0000E-09, indicating
that the current hold time for the setup and hold trigger is 2 ns.
TRIGger:{A|B}:LOGIc:SETHold:QUAlify
This command sets or queries the Setup/Hold Trigger qualification. This is
equivalent to selecting Setup/Hold Setup from the Trig menu and selecting Occurs
or Logic in the Trigger if Setup/Hold drop-down list box.
NOTE. If you use the LOGIc argument, you must specify the channel logic
conditions.
Group
Trigger
Syntax
TRIGger:{A|B}:LOGIc:SETHol d:QUAlify {OCCurs|LOGIc}
TRIGger:{A|B}:LOGIc:SETHol d:QUAlify?
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-515
To Next Page
Loading...
Need help?
General
