Commands Listed in Alphabetical Order
TRIGger:A:CA
N:DATa:VALue
CAN option only: This command sets or quires the binary data string used for
CAN Trigger if the trigger condition is ID or IDANDDATA.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:CAN:DATa:VALue <String>
TRIGger:A:CAN:DATa:VALue?
Arguments
String is up to 32 bits specifying the CAN data value.
Examples
TRIGGER:A:CAN:DATA:VALUE “1011” sets the CAN data value to 1011.
TRIGGER:A:CAN:DATA:VALUE? might return
:TRIGGER:A:CAN:DATA:SOURC E 10111, indicating that the CAN data value
is set to 10111.
TRIGger:A:CAN:FORMat
CAN option only: This command sets or queries the CAN data format.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:CAN:FORMat {BINary|HEX}
TRIGger:A:CAN:FORMat?
Arguments
BINary specifies binary as the CAN data format.
HEX spec ifies hexadecimal as the CAN data format.
Examples
TRIGGER:A:CAN:FORMAT BINARY sets the CAN trigger data format to bin
ary.
TRIGGER:A:CAN:FORMAT? might return :TRIGGER:A:CAN:DATA:FORMAT
HEX
, indicating that the CAN data format is set to hexadecimal.
TRIGger:A:CAN:FRAMEtype
CAN option only: This command sets or queries the CAN trigger frame type.
2-554 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
