Commands Listed in Alphabetical Order
Examples
LIMIT:BEEP ON c
auses a beep when any waveform data exceeds the limits
specified in the limit test.
LIMIT:BEEP? m
ight return
:LIMIT:BEEP 0, indicating that the instrument will
not beep when waveform data exceeds the limits specified in the limit test.
LIMit:COMpare (No Query Form)
This command resets the Limit Test comparison template.
NOTE. The command works only if the LT Limit Test option is enabled.
Group
Limit Test
Syntax
LIMit:COMpare {RESet}
Arguments
RESet resets the Limit template to “None.”
Examples
LIMIT:COMPARE RESET sets the Limit template to None.
LIMit:COMpare:CH<x>
This command sets or queries the template against w hich to compare the
waveform acquired from the channel specified by x. The template can be a
waveform saved in any of the reference locations (REF1 through REF4) or none.
NOTE. The command works only if the LT Limit Test option is enabled.
Group
Limit Test
Syntax
LIMit:COMpare:CH<x> {NONe|REF<x>}
LIMit:COMpare:CH<x>?
Arguments
NONe turns off template testing for the channel specified by CH<x>.
CH<x> selects which channel waveform to use as the template against which to
compare the waveforms acquired by the specified channel (CH<x>).
2-266 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
