Commands Listed in Alphabetical Order
Syntax
CH<x>:PRObe:I
D:TYPe?
Examples
CH1:PROBE:ID:TYPE? might return :CH1:PROBE:
ID:TYPE "P6203"
,
indicating that P6203-type probe is attached to Channel 1.
CH<x>:PRObe:INPUTMode
This command sets or queries the input mode of the probe that is attached to
the specified channel.
Group
Vertical
Syntax
CH<x>:PRObe:INPUTMode
{makeEnumList(signalPathMg r_probeTipMode}
CH<x>:PRObe:INPUTMode?
Arguments
DEFault sets to the default.
DIFFerential sets the probe to route differential signals to the host.
COMmonmode sets the probe to route common-mode signals to the host.
A sets the probe to route single-ended A signals to the host.
B sets the probe to route single-ended B signals to the host.
Examples
CH1:PROBE:INPUTMODE 5.0 sets the attached probe to C hannel 1 to its 5
Ampere range.
CH1:PROBE:INPUTMODE? might return :CH1:PROB E:INPUTMODE A, indicating
that the input mode of the probe that is attached to the Channel 1 is set to
DEFAULT
CH<x>:PRObe:INPUTMode:AOFFSet
This command sets or queries the requested A mode offset control of the probe
that is attached to the specified channel.
Group
Vertical
Syntax
CH<x>:PRObe:INPUTMode:AOFF Set
CH<x>:PRObe:INPUTMode:AOFF Set?
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-119
To Next Page
Loading...
Need help?
General
