Commands Listed in Alphabetical Order
SEARCH:SEARCH
1:TRIGGER:A:LEVEL:REF1?
might return
:SEARCH:SEARCH1:TRIGGER:A: LEVEL:REF1 200.0000E-3, indicating that
the Ref erence 1 waveform trigger level for search 1 is set to 200 mV.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:FUNCtion
This command sets or queries the logic operator for a pattern or state trigger
search to determine w here to place a mark. <x> is the search number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :LOGIc:FUNCtion {AND|NANd|NOR|O R}
SEARCH:SEARCH<x>:TRIGger:A :LOGIc:FUNCtion?
Arguments
AND places a mark if all conditions are true.
NANd places a mark if any of the conditions are false.
NOR places a mark if all conditions are false.
OR placesamarkifanyoftheconditionsaretrue.
Examples
SEARCH:SEARCH1:TRIGGER:A:L OGIC:FUNCTION AND sets the trigger a logic
functionforsearch1toAND.
SEARCH:SEARCH1:TRIGGER:A:L OGIC:FUNCTION? might return
:SEARCH:SEARCH1:TRIGGER:A: LOGIC:FUNCTION NOR, indicating that the
logic function for search 1 is set to NOR.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut:CH<x>
This command sets or queries the Boolean logic criteria for a pattern or state
trigger search to determine where to place a mark.
<x> is the search number
or the channel number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :LOGIc:INPut:CH<x> {HIGH| LOW|X}
SEARCH:SEARCH<x>:TRIGger:A :LOGIc:INPut:CH<x>?
Arguments
HIGH specifies the logic high.
LOW specifiesthelogiclow.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-449
To Next Page
Loading...
Need help?
General
