Commands Listed in Alphabetical Order
This command is
the equivalent of selecting Cursor Setup from the Cursors menu,
selecting V Bars Cursor Type, and then viewing or editing the desired cursor
position.
Group
Cursor
Syntax
CURSor:VBArs:POSITION<x> <NR3>
CURSor:VBArs:POSITION<x>?
Related Commands
CURSor:VBArs:UNIts
Arguments
<NR3> specifies the cursor position.
Returns
A floating point value with an exponent.
Examples
CURSor:VBArs:POSITION2 9.00E-6 positions the cursor2 vertical bar cursor
at 9 ms.
CURSor:VBArs:POSITION1? this command might return
:CURSOR:VBARS:POSITION1 1.0000E-06, indicating that the
cursor1 vertical bar is positioned at 1 ms.
CURSor:VBArs:POS<x>
This command sets or queries the horizontal position for vertical bar cursors. The
cursor is specifi ed by x, which can be 1 or 2. Values are with respect to trigger
position or the zero reference point for the designated waveform (if horizontal
units are not set to time). Use the CURSor:VBArs:UNIts command to specify
units. The position can appear in units of base or 1/base.
This command is the equivalent of selecting Cursor Setup from the Cursors menu,
selecting V Bars Cursor Type, and then viewing or editing the desired cursor
position.
Group
Cursor
Syntax
CURSor:VBArs:POS<x> <NR3>
CURSor:VBArs:POS<x>?
Related Commands
CURSor:VBArs:UNIts
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-139
To Next Page
Loading...
Need help?
General
