Commands Listed in Alphabetical Order
X specifies a “do
n’t care” state.
Examples
SEARCH:SEARCH1:TRIGGER:A: LOGIC:INPUT:CH2 HIGH sets the logic input
for Channel 1 to HIGH.
SEARCH:SEARCH1:TRIGGER:A: LOGIC:INPUT:CH1? might return
:SEARCH:SEARCH1:TRIGGER:A :LOGIC:INPUT:CH1 LOW, indicating the logic
input on Channel 1 for search 1 is set to LOW.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut:MATH<x>
This command sets or queries the Boolean logic criteria for a pattern or state
trigger search to determine where to place a mark. <x> is the search number or
the m ath waveform number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:LOGIc:INPut:MATH<x> {HI GH|LOW|X}
SEARCH:SEARCH<x>:TRIGger: A:LOGIc:INPut:MATH<x>?
Arguments
HIGH specifies a high logic level.
LOW specifies a low logic level.
X specifies a “don’t care” condition.
Examples
SEARCH:SEARCH1:TRIGGER:A: LOGIC:INPUT:MATH2 HIGH sets the Math 2
waveform logic input for search 1 to HIGH.
SEARCH:SEARCH1:TRIGGER:A: LOGIC:INPUT:MATH1? might return
:SEARCH:SEARCH1:TRIGGER:A :LOGIC:INPUT:MATH1 LOW, indicating the
Math 1 waveform logic input for search 1 is set to LOW.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut:REF<x>
This command sets or queries the Boolean logic criteria for a pattern or state
trigger search to determine where to place a mark.
<x> is the search number or
the reference channel number.
Group
Search and Mark
2-450 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
