Commands Listed in Alphabetical Order
Syntax
CURSor:FUNCti
on {OFF|H BArs|VBArs|SCREE N|WAVEform}
CURSor:FUNCtion?
Related Commands
CURSor:STATE
Arguments
OFF removes the cursors from the display but does not change the cursor type.
HBArs specifies horizontal bar cursors, which measure in vertical units.
VBArs specifies vertical bar cursors, which measure in horizontal units.
SCREEN specifies both horizontal and vertical bar cursors, which measure in
horizontal and vertical units specified by the Cursor 1 and Cursor 2 Sources. Use
these cursors to measure anywhere in the waveform display area.
WAVEform specifies paired or split cursors in YT display format for measuring
waveform amplitude and time. In XY and XYZ format, these cursors indicate the
amplitude positions of an XY pair (Ch1 vs Ch2 voltage, where Ch1 is the X axis
and Ch2 is the Y axis) relative to the trigger.
Examples
CURSOR:FUNCTION VBArs selects the vertical bar cursors type.
CURSOR:FUNCTION? might return :CURSor:FUNCtio n HBArs, indicating that
the horizontal bar cursors are currently selected.
CURSor:HBArs? (Query Only)
This query-only command returns the current settings for the horizontal b ar
cursors.
Group
Cursor
Syntax
CURSor:HBArs?
Examples
CURSOR:HBARS? might return the horizontal
bar setting as
:CURSOR:HBARS:POSITION1
320.0000E-03;POSITION2-320.0000E-03;UNITS BASE.
CURSor:HBArs:DELTa? (Query Only)
This query-only command returns the vertical difference between the two
horizontal bar cursors.
2-132 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
