Tektronix DSA70000/B Series

Commands Listed in Alphabetical Order
TRIGGER:A:SER
IAL:LOCKLEN?
might return :TRIGGER:A:SERIAL:LOCKLEN
10000
, indicating that the Pattern string is set to a 10000 bits.
TRIGger:A:SERIAL:LOCKOffset
This command sets or queries the current bit offset into the pattern lock trigger bit
pattern.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:SERIAL:LOCKOffse t <NR1>
TRIGger:A:SERIAL:LOCKOffse t?
Arguments
<NR1> specifies the bit offset. The valid values are 1 to 2147483646.
Examples
TRIGGER:A:SERIAL:LOCKOFFSE T 10 sets the current bit o ffset to 10 bits.
TRIGGER:A:SERIAL:LOCKOFFSE T? might return
:TRIGGER:A:SERIAL:LOCKOFFS ET 20, indicating that the current bit offset is
set to a 20 bits.
TRIGger:A:SERIAL:SOUrce
This command sets or queries the serial data source channel.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:SERIAL:SOUrce {CH1|CH2|CH3|CH4}
TRIGger:A:SERIAL:SOUrce?
Arguments
CH1-4 specifies one of the input channels.
Examples
TRIGGER:A:SERIAL:SOURCE CH1 sets the serial data source channel to CH1.
TRIGGER:A:SERIAL:SOURCE? might return:TRIGGER:A:SERIAL:SOURCE
CH4
, indicating that the serial data source channel is set to CH4.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-587