Tektronix DSA70000/B Series Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
MEASUrement:R
EFLevel:PERCent:MID<x> <NR3>
MEASUrement:REFLevel:PERC ent:MID<x>?
Related Commands
MEASUrement:REFLevel:METHod
Arguments
<NR3> is the mid reference level, ranging from 0 to 100%. The default mid
reference level is 50%.
Examples
MEASUREMENT:REFLEVEL:PERC ENT:MID2 40
sets the mid2 reference level
to 40% of HIGH.
MEASUREMENT:REFLEVEL:PERC ENT:MID2?
might return
:MEASUREMENT:REFLEVEL:PER CENT:MID2 45, indicating that the
percentage mid2 reference level is set to 45% of HIGH.
MEASUrement:SOUrce<x>:SIGType
This comma nd sets or queries the type o f input signal used for measurement
SOURCE<x>, 1 or 2.
To ensure accurate measurements, use this command to specify the input-signal
type for the measurement source.
Conditions
This command is valid only if the instrument has Option MTM is installed
Group
Measurement
Syntax
MEASUrement:SOUrce<x>:SIG Type {PULse|EYE}
MEASUrement:SOUrce<x>:SIG Type?
Arguments
PULSE is for generic signals that are not associated with synchronous
communications standards.
EYE is for synchronous-communication signals with NRZ-like characteristics
(nonreturn to zero).
Examples
MEASUREMENT:SOURCE1:SIGTY PE PULSE selects Pulse as the signal type for
source 1.
MEASUREMENT:SOURCE1:SIGTY PE? might return
:MEASUREMENT:SOURCE1:SIGT YPE EYE, indicating that the signal type for
source 1 is EYE.
2-408 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix DSA70000/B Series Specifications

General

Brand	Tektronix
Model	DSA70000/B Series
Category	Test Equipment
Language	English