Tektronix DSA70000/B Series Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
TRIGger:{A|B}
:EDGE:SLOpe:CH<x> {RISe|FALL|EITher}
TRIGger:{A|B}:EDGE:SLOpe:C H<x>?
Related Commands
TRIGger:{A|B}:EDGE:SOUrce, TRIGger:{A|B}:EDGE:COUPling
Arguments
RISE specifies to trigger on the rising or positive edge of a signal.
FALL specifies to trigger on the falling or negative edge of a signal.
EITHER specifies to trigger on either the rising or falling edge of a signal.
Examples
TRIGGER:A:EDGE:SLOPE:CH2 RISE sets the Channel 2 edge trigger slope to
rising or positive
TRIGGER:A:EDGE:SLOPE:CH1? might return :TRIGGER:A:EDGE:SLOPE
FALL
, indicating that the A edge trigger slope is negative.
TRIGger:{A|B}:EDGE:SOUrce
This command sets or queries the source for the edge trigger. This command is
equivalent to selecting Event Trigger Setup from the Trig menu and then choosing
from the Source drop-down list.
Group
Trigger
Syntax
TRIGger:{A|B}:EDGE:SOUrce {AUXiliary|CH<x >|LINE}
TRIGger:{A|B}:EDGE:SOUrce?
Related Commands
TRIGger:{A|B}:EDGE:SLOpe, TRIGger:{A|B}:EDGE:COUPling,
TRIGger:{A|B}:EDGE?, TRIGger:B:STATE
Arguments
AUXiliary specifies an external trigger using the Auxiliary Trigger Input.
CH<x> specifies one input channel as the edge trigger source.
LINE specifies AC line voltage, and is for A Trigger only.
Examples
TRIGGER:A:EDGE:SOURCE CH2 sets the A edge trigger source to input
cha
nnel CH2.
TRIGGER:A:EDGE:SOURCE? might return :TRIGGER:A:EDGE:SOURCE CH1,
in
dicating that the A edge trigger source is set to input channel CH1.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-501

Tektronix DSA70000/B Series Specifications

General

Brand	Tektronix
Model	DSA70000/B Series
Category	Test Equipment
Language	English