Commands Listed in Alphabetical Order
Group
Measurement
Syntax
MEASUrement:MEAS<x>:STDde v?
Examples
MEASUREMENT:MEAS1:STDDEV? might return :MEASUREMENT:MEAS1:STDDEV
21.0E-12.
MEASUrement:MEAS<x>:TYPe
This command sets or queries the measurement type defined for the specified
measurement slot. The measurement slot is specified by x, which ranges from 1
through 8. This command is equivalent to selecting Measurement Setup from the
Measure menu and then choosing the desired measurement type.
Group
Measurement
Syntax
ME
ASUrement:MEAS<x>:TYPe {AMPlitude|AREa|
BURst|CARea|CMEan|CRMs|DE Lay|DISTDUty|
EXTINCTDB|EXTINCTPCT|EXTI NCTRATIO|EYEHeight|
EY
EWIdth|FALL|FREQuency|HIGH| HITs|LOW|
MAXimum|MEAN|MEDian|MINIm um|NCROss|NDUty|
NOVershoot|NWIdth|PBASe|P CROss|PCTCROss|PDUty|
PE
AKHits|PERIod|PHAse|PK2Pk|P KPKJitter|
PKPKNoise|POVershoot|PTOP |PWIdth|QFACtor|
RISe|RMS|RMSJitter|RMSNoi se|SIGMA1|SIGMA2|
S
IGMA3|SIXSigmajit|SNRatio|ST Ddev|UNDEFINED| WAVEFORMS}
MEASUrement:MEAS<x>:TYPe?
Arguments
AMPlitude measures the amplitude of the selected waveform. In other words, it
measures the high value less the low value measured over the entire waveform or
gated region.
Amplitude = High - Low
AREa measures the voltage over time. The a rea is over the entire waveform or
gated region and is measured in volt-seconds. The area measured above the
ground is positive, while the area below ground is negative.
BURst measures the duration of a burst. The measurement is made over the entire
waveform or gated region.
CARea (cycle area) measures the voltage over time. In other words, it measures, in
volt-seconds, the area over the first cycle in the waveform or the first cycle in the
gated region. The area measured above the common reference point is positive,
while the area below the common reference point is negative.
2-396 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
