Commands Listed in Alphabetical Order
Examples
WFMINPRE:ENCD
G ASCii
sets the format of incoming waveform data to A SCII
format.
WFMINPRE:ENC
DG?
might return :WFMIN PRE:ENCDG BINary, indicating that
the incoming waveform data is in binary format.
WFMInpre:NR_FR
This command sets or returns one frame, indicating the number of frames in the
transmitted waveform record.
Group
Waveform Transfer
Syntax
WFMInpre:NR_FR
WFMInpre:NR_FR?
Related Commands
CURVe, DATa, DATa:STARt, DATa:STOP, SAVe:WAVEform,
SAVe:WAVEform:FILEFormat, WFMInpre:NR_Pt, WFMOutpre:NR_FR?,
WFMOutpre:NR_Pt?
Examples
WFMINPRE:NR_FR 4 specifying to send 4 data frames in the transmitted waveform
record.
WFMINPRE:NR_FR? might return :WFMINPR E:NR_FR 1, indicating that there
is 1 data frame in the transmitted waveform record.
WFMInpre:NR_Pt
This command sets or returns the number of data points that are in the transmitted
waveform record.
Group
Waveform Transfer
Syntax
WFMInpre:NR_Pt <NR1>
WFMInpre:NR_Pt?
Related Commands
CURVe, DATa, DATa:STARt, DATa:STOP, SAVe:WAVEform,
SAVe:WAVEform:FILEFormat, WFMInpre:NR_FR, WFMOutpre:NR_FR?,
WFMOutpre:NR_Pt?
2-632 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Need help?
General
