Tektronix DSA70000/B Series

Commands Listed in Alphabetical Order
TRIGger:A:CA
N:CONDition
CAN option only: This command sets or returns the CAN condition.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:CAN:CONDition
{SOF|FRAMEtype|IDENTifier |DATA|IDANDDATA|EOF|ACKMISS}
TRIGger:A:CAN:CONDition?
Arguments
SOF enables triggering on the start of frame.
FRAMEtype enables triggering on the type of frame.
IDENTifier enables triggering on a matching identifier.
DATA enables triggering on matching data.
IDANDDATA enables triggering on a matching identifier an d matching data.
EOF enables triggering on the end of frame.
ACKMISS enables triggering on a missing acknowledge.
ERROR enables triggering on an error within a frame.
Examples
TRIGGER:A:CAN:CONDITION DATA enables triggering on matching CAN data.
TRIGGER:A:CAN:CONDITION? might return : TRIGGER:A:CAN:CONDITION
EOF
, indicating that the triggering is set on the end of frame.
TRIGger:A:CAN:DATa:DIRection
CAN option only: This command sets or queries the CAN trigger condition to be
valid on a READ, WRITE, or either.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:CAN:DATa:DIRect ion {READ|WRITE|NOCARE}
TRIGger:A:CAN:DATa:DIRect ion?
Arguments
READ sets the CAN data direction to READ.
WRITE sets the CAN data direction to WRITE.
NOCARE sets the CAN data d irection to either.
2-552 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual