Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIGger:A:GLItch:WIDth
This command sets or queries the glitch width for a glitch trigger search to
determine where to place a mark. <x> is the search number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :GLItch:WIDth <NR3>
SEARCH:SEARCH<x>:TRIGger:A :GLItch:WIDth?
Arguments
<NR3> specifies the glitch width in seconds.
Examples
SEARCH:SEARCH1:TRIGGER:A:G LITCH:WIDTH 0.000000002 sets the
search1 glitch width to 2.0 n s.
SEARCH:SEARCH1:TRIGGER:A:G LITCH:WIDTH? might return
:SEARCH:SEARCH1:TRIGGER:A: GLITCH:WIDTH 1.50E-6, indicating that the
search 1 glitch width is set to 1.50 μs.
SEARCH:SEARCH<x>:TRIGger:A:LEVel:CH<x>
This command sets or queries the le v el for an edge trigger search to determine
where to place a mark.
<x> is the search number or the channel number. Each
channel can have an independent level.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :LEVel:CH<x> {<NR3>|ECL|TTL}
SEARCH:SEARCH<x>:TRIGger:A :LEVel:CH<x>?
Arguments
<NR3> specifies the trigger level, in volts.
ECL specifies a -1.3 V trigger l evel.
TTL specifies a 1.4 V trigger level.
Examples
SEARCH:SEARCH1:TRIGGER:A:L EVEL:CH2 1.0 sets the Channel 1 A trigger
level for search 1 to 1.0 Volts.
SEARCH:SEARCH1:TRIGGER:A:L EVEL:CH1? might return
:SEARCH:SEARCH1:TRIGGER:A: LEVEL:CH1 200.0000E-3, indicating the
Channel 1 trigger level for search 1 is 200 mV.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-447
To Next Page
Loading...
