Tektronix DSA70000/B Series Programmer's Manual

Commands Listed in Alphabetical Order
WFMInpre:BYT
_Or
This command sets or queries which byte of binary waveform data is transmitted
first for incoming waveform data when data points require more than one byte.
This specific
ationonlyhasmeaningwhenWFMInpre:ENCdg is set to BIN and
WFMInpre:BYT_Nr is greater than 1.
Group
Waveform Transfer
Syntax
WFMInpre:BYT_Or {LSB|MSB}
WFMInpre:BYT_Or?
Related Commands
WFMInpre:ENCdg, WFMInpre:BYT_Nr, WFMOutpre:BYT_Or
Arguments
LSB specifies that the least significant byte will be transmitted first.
MSB specifies that the most signifi cant byte will be transmitted first.
Examples
WFMINPRE:BYT_OR MSB sets the most significant incoming byte of incoming
waveform data to be transmitted first.
WFMINPRE:BYT_OR? might return :WFMINPRE:BYT_OR LSB, indicating that the
least significant incoming CURVe data byte will be transmitted first.
WFMInpre:ENCdg
This command sets or queries the type of encoding for incoming waveform data.
Group
Waveform Transfer
Syntax
WFMInpre:ENCdg {ASCii|BINary}
WFMInpre:ENCdg?
Related Commands
WFMOutpre:ENCdg
Arguments
ASCii specifies that the
incoming data is in
ASCiiII format.
BINary specifies that the incoming data is in a binary format whose further
interpretation requi
res knowledge of BYT_NR, BIT_NR, BN_FMT, and
BYT_OR.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-631

Tektronix DSA70000/B Series Specifications

General

Brand	Tektronix
Model	DSA70000/B Series
Category	Test Equipment
Language	English