Commands Listed in Alphabetical Order
to selecting B E
vent (Delayed) Trigger Setup from the Trig menu, selecting the A
→B Seq tab, choosing Trig on nth event, and setting the desired Trig Event value.
Group
Trigger
Syntax
TRIGger:B:EVENTS:COUNt <NR1>
TRIGger:B:EVENTS:COUNt?
Related Commands
TRIGger:B:EVENTS?, TRIGger:B:STATE
Arguments
<NR1> is the number of B trigger events, which can range from 1 to 10,000,000.
Examples
TRIGGER:B:EVENTS:COUNT 4 sets the number of B trigger events to four.
TRIGGER:B:EVENTS:COUNT? might return :TRIGGER :B:EVENTS:COUNT 2,
indicating that two events must occur after the A trigger before the B trigger
can occur.
TRIGger:B:PULse:WINdow:POLarity
This command sets or queries the pulse trigger window polarity of the selected
trigger Source. The instrument triggers when the signal exits the window. This
command is available only when the Window Event is set to Inside > t and not
available for the rest of the window events. The logic selection is available only
when the polarity is set to Either.
Group
Trigger
Syntax
TRIGger:B:PULse:WINdow:PO Larity {EITher|NEGAtive|P OSITIVe}
TRIGger:B:PULse:WINdow:PO Larity?
Arguments
EITher specifi es positive or negative polarity.
NEGAtive specifies a negative polarity.
POSITIVe specifies a positive polarity.
Examples
TRIGGER:B:PULSE:WINDOW:PO LARITY P OSITIVE sets the window polarity to
positive.
2-610 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
