Commands Listed in Alphabetical Order
Examples
WFMOUTPRE:YOF
F?
might return :WFMOUTPRE :YOFF -50.0000E+0, indicating
that the position indicator for the waveform was 50 digitizing levels (2 divisions)
below center s creen.
WFMOutpre:Y
UNit? (Query Only)
This query-only command returns the vertical units for the waveform specified by
the DATa:SOUrce command.
An error is reported if the DATa:SOUrce waveform does not exist.
Group
Waveform Transfer
Syntax
WFMOutpre:YUNit?
Related Commands
DATa:SOUrce
Examples
WFMOUTPRE:YUNIT? might return :WFMOUTPRE:YUNIT "dB", indicating that
the v ertical units for t
he waveform are measured in decibels.
WFMOutpre:YZEro? (Query Only)
This query-only command returns the vertical offset in units specified by
WFMOutpre:YUNit? for the waveform specified by the DATa:SOUrce command.
An error is reported if the DATa:SOUrce waveform does not exist.
Group
Waveform Transfer
Syntax
WFMOutpre:YZEro?
Related Commands
DATa:SOUrce, WFMOutpre:YUNit?
Examples
WFMOUTPRE:YZERO? might return :WFMOUTPRE:YZERO -100.0000E-3,
indicating that vertical offset is set to -100 mV.
2-648 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
