Commands Listed in Alphabetical Order
SEARCH:SEARCH
<x>:TRIGger:A:DDRMemory:STRO BEsource?
Arguments
CH<x> specifies the input channel as the search source, where <x> is the channel
number.
MATH<x> specifies the math waveform as the search source, where <x> = 1, 2, 3
or 4.
REF<x> specifies the reference waveform as the se arch source, where <x> =
1, 2, 3 or 4.
Examples
SEARCH:SEARCH1:TRIGGER:A: DDRMEMORY:STROBESOURCE RE F2 sets the
DDR strobe source to REF2.
SEARCH:SEARCH1:TRIGGER:A: DDRMEMORY:STROBESOURCE? might return
:SEARCH:SEARCH1:TRIGGER:A :DDRMEMORY:STROBESOURCE C H1, indicating
that the DDR strobe source is set to CH1.
SEARCH:SEARCH<x>:TRIGger:A:EDGE:SLOpe:CH<x>
This command sets or queries the slope for an edge trigger search to determine
where to place a mark. <x> is the search number or the channel number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:EDGE:SLOpe:CH<x>
{RISe|FALL|EITher}
SEARCH:SEARCH<x>:TRIGger: A:EDGE:SLOpe:CH<x>?
Arguments
RISe specifies a rising edge.
FALL specifies a falling edge.
EITher specifi es either rising or falling edge.
Examples
SEARCH:SEARCH1:TRIGGER:A: EDGE:SLOPE:CH2 RISE sets the Channel 2
slope for search 1 to rise.
SEARCH:SEARCH1:TRIGGER:A: EDGE:SLOPE:CH1? might return
:SEARCH:SEARCH1:TRIGGER:A :EDGE:SLOPE:CH1 RISE, indicating that the
slope for the Channel 1 trigger for search 1 is rise.
2-442 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
