Tektronix DSA70000/B Series Programmer's Manual

Commands Listed in Alphabetical Order
Examples
TRIGGER:A:LOG
IC:THRESHOLD?
might return
:TRIGGER:A:LOGIC:THRESHOLD CH1 24.0000E-03; CH2
1.2000E+00;CH3 1.2000E+00; CH4 1.2000E+00
, indicating the threshold
voltages for the channels in an A logic trigger are as follows: channel 1 = 24 mV;
channel 2 = 1.2 V; channel 3 = 1.2 V; channel 4 = 1.2 V.
TRIGger:{A|B}:LOGIc:THReshold:CH<x>
This command sets or queries the A or B logic trigger threshold voltage for
the channel, specified by x, which ranges from 1 through 4. This command is
equivalent to selecting A or B Event Trigger Setup from the Trig menu, choosing
a logic trigger type, such as State or Pattern, and setting the Input Threshold
voltage for the desired channel.
Group
Trigger
Syntax
TRIGger:{A|B}:LOGIc:THResh old:CH<x> <NR3>
TRIGger:{A|B}:LOGIc:THResh old:CH<x>?
Related Commands
TRIGger:{A|B}:LOGIc:INPut?
Arguments
<NR3> spe cifies the threshold voltage.
Examples
TRIGGER:A:LOGICTHRESHOLD:C H2 3.0E-3 sets the A logic trigger threshold
voltage for Channel 2 to 3 mV.
TRIGGER:A:LOGIC:THRESHOLD: CH3? might return
:TRIGGER:A:LOGIC:THRESHOLD :CH3 1.2000E+00, indicating that the A
logic trigger threshold voltage for Channel 3 is 1.2 V.
TRIGger:{A|B}:LOWerthreshold:CH<x>
This command sets or queries the A or B lower trigger level for
TRIGger:LVLSrcpreferenceTRIGger:LVLSrcpreference SRCDependent or
SRCIndependent modes for the channel, specified by x, which ranges from 1
through 4.
Group
Trigger
Syntax
TRIGger:{A|B}:LOWerthresho ld:CH<x> {ECL|TTL|<NR3>}
TRIGger:{A|B}:LOWerthresho ld:CH<x>?
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-519

Tektronix DSA70000/B Series Specifications

General

Brand	Tektronix
Model	DSA70000/B Series
Category	Test Equipment
Language	English