TRENDnet TL2-E284 - Mac-Address-Table Static Unicast

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
33-3
mac-address-table static unicast
To create a static unicast entry in L2 FBD.
Command
mac-address-table static unicast <aa:aa:aa:aa:aa:aa> vlan
<vlan-id(1-4094)> [recv-port <interface-type> <interface-id>]
interface ([<interface-type> <0/a-b,0/c,...>]
[<interface-type> <0/a-b,0/c,...>] [port-channel <a,b,c-d>])
[status { permanent | deleteOnReset | deleteOnTimeout }]
no mac-address-table static unicast <aa:aa:aa:aa:aa:aa> vlan
<vlan-id(1-4094)> [recv-port <interface-type>
<interface-id>]
Syntax Description
aa:aa:aa:aa:aa:aa
MAC address of the static unicast.
vlan vlan-id(1-4094)
VLAN of the static unicast.
recv-port
interface-type
interface-id
The reveived port of the static unicast.
Interface-type including Fa (Fast Ethernet) or Gi
(Gigabit Ethernet).
Interface-id is slot/port number.
interface
The interface to forward the static unicast.
interface-type
0/a,0/b,...
Specify the port type and ID to forward.
Interface-type including Fa (Fast Ethernet) or Gi
(Gigabit Ethernet).
Interface-id is slot/port number.
port-channel a,b,...
Specify the port channel ID to forward.
status
Specify the status of this static unicast.
permanent
The static multicast will keep alive.
deleteOnReset
The static multicast will be deleted after switch
reset.
deleteOnTimeout
The static multicast will be deleted when aging time
out.
Default Settings
Status – Permanent
Command Modes
Global Configuration Mode
User Guidelines
Using no form to delete a configured entry.
Example
switch(config)# mac-address-table static unicast
aa:bb:cc:dd:ee:ff vlan 1 int fa 0/1 status deleteonreset
Command History
Version
History
1.00.001
This command was introduced