TRENDnet TL2-E284 - Channel-Group; Lacp Port-Priority

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
30-3
Command History
Version
History
1.00.001
This command was introduced
channel-group
To join a port to a channel group.
Command
channel-group <channel-group-number(1-65535)> mode {active |
passive | on}
no channel-group
Syntax Description
channel-group-n
umber(1-65535)
Specify which channel group to configure.
mode active
Activates the LACP negotiation.
mode passive
LACP negotiation starts only when LACP packet is
received.
mode on
Disables the LACP negotiation, using manual
aggregation.
Command Modes
Interface Configuration Mode
User Guidelines
1. Port-channel group must be crested before assign port to a channel group.
2. The MTU of the port and channel group must be the same.
Example
switch(config-if)# channel-group 1 mode active
Command History
Version
History
1.00.001
This command was introduced
lacp port-priority
To set the LACP port priority of a port.
Command
lacp port-priority <0-65535>
no lacp port-priority
Syntax Description
0-65535
Specify the port priority of the port.
Default Settings
128
Command Modes
Interface Configuration Mode