TRENDnet TL2-E284 - Spanning-Tree Pathcost Dynamic; Spanning-Tree Transmit Hold-Count

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
28-3
spanning-tree pathcost dynamic
To enable the dynamic pathcost according to the port speed..
Command
spanning-tree pathcost dynamic
no spanning-tree pathcost dynamic
Default Settings
Disable
Command Modes
Global Configuration Mode
User Guidelines
1. If the cost has been configured on a CIST or a RSTP interface, then this
command won‟t take effect on those interfaces.
2. If the cost has been configured on a port of MST instance, then this command
won‟t take effect on that instance. However, the pathcost of all the other instances
on the same port will still be calculated dynamically.
3. Using no form to disable the dynamic pathcost function.
Example
switch(config)# spanning-tree pathcost dynamic
Command History
Version
History
1.00.001
This command was introduced
spanning-tree transmit hold-count
To set a hold counter to limit maximum transmission rate of the Switch.
Command
spanning-tree transmit hold-count <value (1-10)>
no spanning-tree transmit hold-count
Syntax Description
value (1-10)
Specify the value of hold counter.
Default Settings
3
Command Modes
Global Configuration Mode
User Guidelines
Using no form to reset the hold count to default.
Example
switch(config)# spanning-tree transmit hold-count 10
Command History
Version
History
1.00.001
This command was introduced